Kenwood KTF-2010, KTF-3010 Broadcast reception, 8 9. ) ) MHz, 9 ). ) ) MHz, 2Select the broadcast band, 3Select the tuning method, 5Select a station

Broadcast reception

This section shows you how to receive radio broadcasts. You can store up to 40 stations in the memory and recall them

8 with a single touch of the key.

Preparation

Switch the ON/STANDBY key to ON.

KTF-3010/KTF-2010 (En)

The figure shows an example for the KTF-3010

AM-FM STEREO SYNTHESIZER TUNER			KTF-3010	HIGHBLEND		TUNING/MULTI CONTROL
				WIDE
ACTIVE				NARROW
	IF BAND	RF ATT	ANT A/B			R D S
RECEPTION				RFATT		EON
						BAND
	PTY/	DISPLAY	MEMORY
TA/NEWS	PTY SCARCH			TUNING MODE	+10/CLEAR
						P. CALL

ON/STANDBY

1 2 3 4 5 6 7 8 9 0/CHARA. DOWN UP

: Keys or controls to be used in this operation.

Receiving a broadcast station (other than RDS stations)

1Switch the amplifier input to the tuner input.

2Select the broadcast band.

BAND

3Select the tuning method.

KTF-2010KTF-3010

AUTO/MANUAL TUNING MODE

4Make the AR indicator light. (FM band only)

(KTF-3010 only)

ACTIVE

RECEPTION

5Select a station.

	TUNING/MULTI CONTROL
To decrease	To increase
frequency	frequency
DOWN	UP

............................................................................................................................ ]

Each press switches the band as follows: 1 FM

2MW

3LW (U. K. only)

		FMLW - -	ANT A
			8 9. ) ) MHz
		MW
	“FM”, “MW” or “LW” is displayed.
				]
The tuner switches over as follows each time you press the key while
receiving a FM broadcast.
		1 AUTO/STEREO	: AUTO lit (auto tuning)
		2 HIGH BLEND	: AUTO lit, HIGH BLEND LED lit (auto tuning)
			(available for the FM band with KTF-3010 only)

3MANUAL/MONO : AUTO not lit (manual tuning)

÷Usually, set the switch to AUTO (auto tuning).

Select HIGH BLEND (available with the KTF-3010 only) or MANUAL when the radio waves are weak and there is a lot of noise interference.(The stereo broadcasting is received in monaural during manual tuning.)

............................................................................................................................ ]

Each time the ACTIVE RECEPTION key is pressed, the setting changes.

1 ON (AR indicator lit ): when switching the IF BAND, RF ATT and ANT A/B functions automatically.

2OFF (AR indicator not lit ): when switching these functions manually.

AR	ANT A
FM - -	8 9. ) ) MHz
	AUTO

÷Usually, set ACTIVE RECEPTION key to ON.

÷FM broadcasts are received in the optimum reception conditions.

............................................................................................................................ ]

				"TUNED" lights up
				when a station is tuned.
	AR	- -	ANT A		STEREO
	FM		9 ). ) ) MHz
					TUNED
					AUTO
			Frequency	display
Auto tuning		: The next station found is tuned automatically.
Manual tuning		: Keep turning the knob, checking the display, until you
		tune in on a station.