Connection
When handling an optical cable for wiring, use care not to exceed the minimum cable bend radius of 30 mm. If you exceed the minimum bend limit, optical fibers within the optical cable may be damaged.
30R
An Optical cable (Accessory 3) is fixed with a chassis using harness band (Accessory $).
For the sake of safety, be sure to connect the parking sensor.
Connect to the vehicle's parking brake detection switch harness using the supplied relay connector.
Optical output |
|
| Monitor unit |
(Black)
Accessory 4
Parking sensor wire (Green)
PRK SW
To vehicle's reverse lamp harness | Reverse sensor wire (Pink) | |
REVERSE | ||
| ||
| Steering remote control input | |
To Steering remote | (Light Blue/Yellow) | |
REMO.CONT | ||
| ||
D | Dimmer control wire (Orang/White) | |
ILLUMI |
A
Ignition wire (Red)
ACC
B
Battery wire (Yellow)
(5A)
BATT
E
+
Battery
Antenna Cord
Accessory !
Ground wire (Black) - (To car chassis)
C
Receiver unit (front side)
|
|
|
| AV OUTPUT |
|
| PRE OUTPUT | |
|
| AV INPUT 2 |
|
|
|
| REAR | FRONT |
| VIDEO | L | R | L | CENTER | L | L | |
FM/AM antenna input | FM /AM ANTENNA | AV INPUT 1 |
|
| VIDEO | SUB |
| POWER |
VIDEO | L | R | R | [MONO] | R | R | ||
Accessory 5
To Subwoofer system |
| |
| Accessory 1 | |
Accessory # | If no connections are made, do not let | |
the cable come out from the tab. | ||
|
Connect to the terminal that is grounded when either the telephone rings or during conversation.
To connect the Kenwood navigation system, consult your navigation manual.
Connect either to the power control terminal when using the optional power amplifier, or to the antenna control terminal in the vehicle.
To "EXT.AMP.CONT." terminal of the amplifier having the external amp control function.
Mute wire (Brown)
MUTE
(10A)
Power control/ Motor antenna control cable (Blue/White)
P. CONT | ANT CONT |
External amplifier control wire (Pink/Black)
EXT.CONT
4 English