&211(&7,1*72$5(*8/$7('32:(56833/<

To connect the transceiver to an appropriate regulated DC power supply, use an optional PG-2W DC cable.

1Confirm that the power of both the transceiver and the DC power supply is OFF.

2Connect the optional PG-2W DC cable to the DC power supply; the red lead to the positive (+) terminal, and the black lead to the negative (–) terminal.

Fuses (3 A)

3Connect the barrel plug on the DC cable to the DC IN jack of the transceiver.

•While a DC power supply is connected with the DC IN jack, the transceiver automatically initiates charging the PB-45L battery pack.

Note:

XIf the DC power supply voltage is below 12.0 V DC, you may not be able to charge the PB-45L battery pack.

XThe supply voltage must be between 12.0 V and 16.0 V to prevent damaging the transceiver. If the input voltage exceeds approximately 17.5 V, the transceiver automatically turns OFF.

&211(&7,1*72$3&

The USB connector allows you to directly connect to a computer by using a supplied USB cable.

•Download the virtual COM port driver from the URL listed below. http://www.kenwood.com/i/products/info/amateur/software_download.html

PC

PC (USB) port <Baud rate: 9600 bps>

Supplied USB cable

Depending on the usage condition of the USB apparatus, saved content may be lost. Kenwood does not take responsibility for damages or lost content.

7