5Press the PTT, MON, or CAL key to exit Setting Mode.
To begin scanning:
1Press and hold the ▲ key for 1 second.
•
appears on the display.
2When a signal is detected and the QT/ DQT matches, the channel number appears on the display and blinks.
3When the signal is no longer present, the transceiver waits for 5 seconds before scanning continues.
•If a new signal appears before the 5 seconds elapse, the transceiver will remain on the channel until the new signal is no longer present, at which time it will again wait for
5 seconds before continuing.
4To end the scan at any time, press and hold the ▲ key for 1 second.
•The transceiver returns to the channel you were using before you started scanning.
14
