SCAN
Scan monitors for signals on the transceiver channels. While scanning, the transceiver checks for a signal on each channel and only stops if a signal is present.
To begin scanning, press the key programmed as Scan.
•The 
icon appears on the display.
•When a signal is detected on a channel, Scan pauses at that channel. The transceiver will remain on the busy channel until the signal is no longer present, at which time Scan resumes.
To stop scanning, press the Scan key again.
Note: To use Scan, there must be at least 2 channels in the scan sequence.
Temporary Channel Lockout
During scan, you can temporarily remove specific channels from the scanning sequence by selecting them and pressing the key programmed as Scan Delete/Add.
•The channel is no longer scanned. However, when scanning is ended and restarted, the channels are reset and deleted channels will again be in the scanning sequence.
Scan Delete/Add
You can add and remove zones and/or channels to and from scan.
1Select your desired zone and/or channel.
2Press the key programmed as Zone Delete/Add (to add/remove zones) or Scan Delete/Add (to add/remove channels).
•You can also press and hold the key programmed as Scan Delete/Add to add/remove zones.
15