Priority Scan
Note: To use Priority Scan, a Priority channel must be programmed.
When using a single Priority channel, the transceiver will automatically change to the Priority channel when a call is received on that channel, even if a call is being received on a normal channel.
When using dual Priority channels, Priority channel 1 is given precedence over Priority channel 2. So, if a call is received on Priority channel 1 while a call is already on Priority channel 2, the transceiver will change to Priority channel 1.
If the Priority channel has been set as Operator Selectable by your dealer, you can reprogram the Priority channels.
1Select your desired zone and channel.
2Press the key programmed as
3Press 
/
to select “NORMAL”, “PRIORITY 1” ( 
), “PRIORITY 2” ( 
), or “PRIORITY 1&2” ( 
).
4Press 
to save the setting and exit.
Scan Revert
The Scan Revert channel is the channel selected when you press the PTT switch to transmit during scan. Your dealer can program one of the following types of Scan Revert channels:
•Selected: The last channel selected before scan.
•Selected + Talkback: Same as “Selected”, plus you can respond to calls on the channel at which scan is paused.
•Priority 1/ Priority 2: The Priority channel (either Priority 1 or Priority 2).
•Priority 1 + Talkback/ Priority2 + Talkback: Same as “Priority 1/ Priority 2”, plus you can respond to calls on the channel at which scan is paused.
•Last Called + Selected: Same as “Selected + Talkback”, plus you can respond on the last channel on which you receive a call after scan has resumed.
16