Kenwood TK-7150 TK-7150

TK-7150

1. Installing Name Plate

Punch out the name plate card. Then insert the plates

onto the relative function keys.

You can reconfigure the name plates at any time.

3. External Speaker (KES-5)

The external speaker output from the accessory connector

(6 pin) on the rear of the transceiver is 13W/4Ω. Use the KES-5.

3-1. Connection for the KES-5 with the TK-7150

■When taking the AF output from the accessory

connector (6-pin) on the rear of the radio

The following tools are required for changing the connector.

• Extracting tool

The following extracting tool is recommended;

Molex inc. Order No. : J5800-002 (W05-0878-00)

1. Remove the connector with jumper from the external

speaker connector on the rear panel of the radio (Fig. 3-1).

Note : Save the jumper, which is required when the radio

is used without the external speaker.

2. Remove the terminals with the jumper from the connec-

tor housing holes number 5 and 6 using the extracting

tool.

Removing the jumper lead (Fig. 3-2)

1) Insert the extracting tool (J5800-002) into the connec-

tor while pushing the jumper lead in the direction of (a).

2) Push the extracting tool into collapse the barbs of the

crimp terminal.

3) Pull out the lead while continuing to push the extracting

tool in the direction (b).

3. Cut off the end of the protection cover, insert the KES-5

speaker cable into the protective cover.

4. Reinsert the terminal with the black and white stripe lead

into hole number 5, and the terminal with the black lead

into hole number 4 (Fig. 3-3).

5. Install the plug and protective cover on the accessory con-

nector on the rear of the transceiver, then clamp the bot-

tom of the protective cover with the supplied tie wrap.

INSTALLATION

Name plates for

the function keys

Punch out the

name plate cards

Squeeze and

insert the plates

Name plates

Side view of the key

Fig. 1

2. Ignition Sense Cable (KCT-18)

The KCT-18 is an optional cable to use the following func-

tions;

2-1. Ignition Function

The ignition function allows you to turn the transceiver’s

power on and off with the ignition key of your car. When you

are driving with the ignition key on, the horn alert function is

disabled.

2-2. Timed Power Off Function

The timed power off function turns the transceiver’s

power off the time specified with the programming software

(KPG-79D) after the ignition key is turned off. When you are

driving with the ignition key on, the horn alert function is dis-

abled.

The ignition sense function and the timed power off func-

tion can be used at the same time.

2-3. Modification

1. Remove the short plug from the accessory connector (6

pins) on the rear of the transceiver.

2. Cut off the end of the protective cover (accessory), insert

the KCT-18 into the protective cover, and insert it into pin

1 (IGN) of the short plug.

3. Install the short plug and protective cover on the connec-

tor on the rear of the transceiver, then clamp the bottom

of the protective cover with the supplied tie wrap.

Fig. 2

Cut

Tie wrap

Protective cover

KCT-18

Short plug

Square-type plug

(E37-1031-05)

(a)

(b)

Jumper

lead

Extracting tool

(J5800-002)

Crimp terminal

(E23-0613-05)

Barbs

Cut

Tie wrap

Protective cover

Short plug

Black lead

Black/White lead

Speaker cable (to KES-5)