BASIC OPERATIONS

SWITCHING POWER ON/ OFF

Press and hold the switch to switch the transceiver ON.

•A beep sounds and the power-on message momentarily appears.

Press and hold the switch again to switch the transceiver OFF.

ADJUSTING THE VOLUME

Press the VOLkey to increase the volume and the VOLkey to decrease the volume.

•Additionally, you can press and hold the VOL/ keys to continuously change the volume level, rather than adjusting it by only 1 step at a time.

SELECTING A CHANNEL

Press the CHkey to increase the channel number and the CH key to decrease the channel number.

•Additionally, you can press and hold the CH/ keys to continuously change the channel number, rather than changing it by only 1 step at a time.

DIRECT FREQUENCY ENTRY

Besides using the CH/keys to select your pre-programmed memory channels, you can directly enter a VFO station frequency using an optional microphone keypad.

1Press and hold the key programmed as VFO for approximately 1 second.

•The frequency of the currently selected channel appears on the display along with the selected operating mode.

2Enter your desired frequency using a microphone keypad (0 ~ 9).

•Direct entry only allows you to enter down to the 10’s value; 0 is automatically selected for the 1’s value.

3After entering a frequency using the microphone keypad, press the # key.

•To cancel the frequency entry, press the key; the frequency will return to the original frequency before you started to enter your new frequency.

4To exit VFO mode and return to your preprogrammed memory channels, press and hold the VFO key again.

■VFO STEP VALUE

When using the CH/keys to select a frequency in VFO mode, the frequency is adjusted by a pre-determined step value. You can adjust this step value as follows:

1Press the key programmed as VFO.

2Press the <C and D> keys to select the desired digit (10’s, 100’s, 1000’s, etc.).

3Press the CH/keys to select the desired value for the digit you selected in the previous step.

• The default step value is 10 Hz.

4Press thekey to store the new step value and exit the VFO step value adjustment.

SELECTING A MODE

The mode stored with each channel can be temporarily changed. To change the operating mode:

1Press the key programmed as Mode.

2Continuously press the Mode key to cycle through the various available operation modes as displayed below:

USB LSB CW

DATA FSK AM

3After selecting your desired mode, perform no operations for 1 second to return to save the operation mode and exit.

DATA OPERATION

Your dealer can program various settings for FSK and DATA modes. Ask your dealer for details.

8