17 EN

Listening to a source component

1

Use the INPUT SELECTOR knob or keys to select the source

you want to listen to.

The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob.
1“AUX”
2“TUNER”
3“CD/DVD”
4“TAPE” or “MD”
5“VIDEO 1”
6“VIDEO 2”
7“DVD/6CH”
2

Start playback from the selected source.

3

Use the VOLUME CONTROL knob or VOLUME +/- keys to

adjust the volume.

Normal playback
Some preparatory steps are needed before starting playback.

Turning on the receiver

1Turn on the power to the related components.
2Turn on the power to this receiver by pressing POWER ON/
STANDBY key.

Selecting the input mode

If you have selected a component connected to the CD/DVD, VIDEO 2
or DVD/6CH jacks, make sure that the input mode setting is correct for
the type of audio signal to be used. 7

Selecting MD/TAPE

Select the source name corresponding to the component connected to
the MD/TAPE jacks. The initial factory setting is “TAPE”. To change the
source to “MD”, follow the steps below:
1Use the INPUT SELECTOR knob to select “TAPE”.
2Hold down the AUTO key for more than 2 seconds.
•The source indication changes to “MD”.
•To return to the original indication, repeat procedure 2.

Setting the speaker status

Press the SPEAKERS ON/OFF key to switch the speakers ON or
OFF.

Preparing for playback

The speaker indicator lights up.
INPUT SELECTOR
POWER
ON/STANDBY
SPEAKERS
ON/OFF
AUTO
INPUT MODE
INPUT SELECTOR
VOLUME CONTROL
VOLUME +
/
–
INPUT
SELECTOR
*5228/15-18/EN 14/06/2002, 11:58 AM17