13 EN
1Strip coating. 2Push the lever.
3Insert the cord. 4Return the lever.
Setting up the system
Connecting the terminals

Speaker impedance

After confirming the speaker impedance indications printed on the
rear panel of the receiver, connect speakers with matching impedance
ratings. Using speakers with a rated impedance other than that
indicated on the rear panel of the receiver could result in malfunctions
or damage to the speakers or receiver.
• Never short circuit the + and – speaker cords.
• If the left and right speakers are connected inversely or the speaker
cords are connected with reversed polarity, the sound will be
unnatural with ambiguous acoustic imaging. Be sure to connect the
speakers correctly.
Connecting the antennas

AM loop antenna

The supplied loop antenna is for use indoors. Place it as far as possible
from the receiver, TV set, speaker cords and power cord, and adjust
the direction for best reception.

FM indoor antenna

The supplied indoor antenna is for temporary use only. For stable
signal reception we recommend using an outdoor antenna. Disconnect
the indoor antenna when you connect one outdoors.

FM outdoor antenna

Lead the 75Ω coaxial cable connected to the FM outdoor antenna into
the room and connect it to the FM 75Ω terminal.
Use an antenna
adaptor
(Commercially
available)
Attach to the stand
AM loop antenna
FM indoor antenna
FM outdoor antenna

Speaker placement

Front speakers : Place to the front left and right of the listening
position. Front speakers are required for all surround modes.
Center speaker : Place front and center. This speaker stabilizes the
sound image and helps recreate sound motion. Required for surround
playback.
Surround speakers : Place to the direct left and right, or slightly
behind, the listening position at even heights, approximately 1 meter
above the ears of the listeners. These speakers recreate sound
motion and atmosphere. Required for surround playback.
Subwoofer : Reproduces powerful deep bass sounds.
• Although the ideal surround system consists of all the speakers
listed above, if you don't have a center speaker or a subwoofer, you
can divide those signals between the available speakers in the
speaker settings steps to obtain the best possible surround
reproduction from the speakers you have available. %
Front
speaker
Subwoofer
Surround
speaker
Center speaker
Listening
position

AM antenna terminal connections

1Push lever. 2Insert cord. 3Release lever.

FM antenna terminal connections

Insert cord.
S VIDEO
VIDEO 2
IN
DVD
IN
MONITOR
OUT
SUB WOOFER
PRE OUT
VIDEO 2
COAXIAL
DVD
DIGITAL IN
CD / DVD
OPTICAL
VOLTAGE
SELECTOR
AC110V-120V / 220V-240V~
50 / 60Hz
SWITCHED
TOTAL 90W MAX.
AC OUTLETS
AC 220-
240V~
AC 110-
120V~
SPEAKERS
SURROUND
SPEAKERS
(8-16Ω)
CENTER
SPEAKER
(8-16Ω)
FRONT
SPEAKERS
(8-16Ω)
GRAY
WHITE GREEN BLUERED
LC
RL
R
CENTER
SUB
WOOFER
SURROUND
FRONT
DVD / 6CH INPUT
PLAY IN
VIDEO 2
AUDIO
REC OUT PLAY IN
VIDEO1
PHONO REC OUT PLAY IN
MD / TAPE
CD / DVD
L
R
VIDEO 1
OUT
VIDEO 1
IN
VIDEO
VIDEO 2
IN
DVD
IN
MONITOR
OUT
ANTENNA
GND
AM
FM
75Ω
SYSTEM
CONTROL
+
-
+
-
ANTENNA
GND
AM
FM
75Ω
*5228/07-14/EN 14/06/2002, 11:54 AM13