35 EN
In case of difficultyRemote control unit
Cause
•No setup codes registered at the respective
input(s).
•The remote control is set to a different
operation mode.
•Batteries are exhausted.
•The remote control unit is too far away from
the main system, controlling angle is too large,
or there is an obstacle between the receiver
and the remote.
•The audio cords and system control cords are
not connected properly.
•No software is loaded in the source
component.
•An attempt is made to play a tape which is
being recorded in the cassette deck.
•The remote control has not been set to the
operation mode for the component you wish
to control.
Remedy
•Register a setup code at the respective
input(s). º
•Press the any of the REMOTE MODE or INPUT
SELECTOR keys to select the appropriate
operation mode.
•Replace with new batteries.
•Operate the remote control unit within the
controllable range.
•Connect properly referring to “Setting up the
system”.
•Place software in the source component you
want to play.
•Wait until recording has completed.
•Press any of the remote mode keys or
SOURCE key to activate the operation mode
for the component you want to control before
operation. •
Symptom
Certain inputs cannot be selected using the
remote control.
Remote control operation is not possible.
*5228/30-36/EN 14/06/2002, 12:05 PM35