Before applying the power

Preparing the remote control

Loading the batteries

1 Remove the cover.

2 Insert the batteries.

3Close the cover.

•Insert two AAA-size (R03) batteries as indicated by the polarity markings.

Operation

When the STANDBY indicator is lit, the power turns ON when you press

the RECEIVER key on the remote control. When the power comes ON, press the key you want to operate.

Operating range

Remote sensor

(Approx.)

Infrared ray system

•When pressing more than one remote control key successively, press the keys securely by leaving an interval of 1 second or more between keys.

Notes

1.The supplied batteries may have shorter lives than ordinary batteries due to use during operation checks.

2.When the remote-controllable distance gets shorter than before, replace both batteries with new ones.

3.Placing the remote sensor in direct sunlight, or in direct light from a high frequency fluorescent lamp may cause a malfunction.

In such a case, change the location of the system installation to prevent malfunction.

For the U.S.A.
FCC WARNING

This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

–– Reorient or relocate the receiving antenna.

–– Increase the separation between the equipment and this model.

–– Connect the equipment into an outlet on a circuit different from that to which this model is connected.

–– Consult the dealer or an experienced radio / TV technician for help.

For the U.S.A.

Note to CATV system installer

This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

As an ENERGY STAR® Partner, Kenwood

Corporation has determined that this product meets the ENERGY STAR® guidelines for

energy efficiency.This product can save energy.

Saving energy reduces air pollution and lowers utility bills.

4 EN