Kenwood instruction manual Mounting Instructions, VR62VR61

Mounting Instructions

1.Remove the screw from each end of the enclosure as shown below.

2.Align the bracket slots with the mounting holes on each end of the enclosure. Make sure the four openings in the bracket arms face upward.

3.Onto each of the two supplied hex-head screws, place a lock washer, and a flat washer. Thread them at least three complete turns into both of the enclosure’s side mounting holes, and tighten them securely.

4.The bracket /enclosure assembly may be mounted vertically or horizontally.

5.The enclosure may be adjusted to any angle by loosening the 2 hex-head screws, turning the enclosure to the desired angle, and then re-tightening the screws.

1/4 INCH FLAT WASHER	BRACKET/WALLMOUNT	SCREW 1/4 INCH-20
2 PLACES		X 1.25 INCH LONG
		HEX HEAD
		2 PLACES

1/4 INCH LOCK WASHER

2 PLACES

REMOVE SCREWS

FROM BOTH SIDES

MOUNTING POINT

1/4-20 THREADED HOLE

VR62VR61

6 – VR61 and VR62