Bracket Dimensions
VR61 10.00"(254)
VR62 16.00"(406.4)
0.40" x 2.25" Full radius (10.16 x 57.15)
0.13"(3.3)
11.50"
(292.1)
VR61 15.69"(398.5) VR62 22.44"(570.0)
NOTE: Dimensions are in inches, Dimensions in brackets are mm Tolerance ± 0.03"(0.8 mm)
3.00"(76.2)
8.00"(203.2)
2.00"(50.8)
0.31" x 1.38" Full radius (7.87 x 35.05)
Horn Rotation Instructions
•The high frequency horn can be rotated through 90 degrees to allow you to choose the best horn pattern for your installation.
•From the factory, the horn is set to give a 90 degrees horizontal horn pattern if the loudspeaker is mounted vertically.
•If you mount the loudspeaker horizontally, you can rotate the horn through 90 degrees to compensate. This is done using a medium phillips screwdriver as follows:
1.Remove all the screws attaching the grille to the enclosure, and gently remove the grille.
2.Remove the four screws attaching the horn to the enclosure.
3.Gently pry the horn assembly away from the enclosure (it may be stuck due to the gasket seal). Support the horn so it does not drop when it comes free.
4.Rotate the horn through 90 degrees (the horn is
marked with 60 and 90 on the edges to show the direction of the pattern). Be careful not to pull on the speaker wires.
5.Reattach the horn to the enclosure using the four screws.
6.Replace the grille and secure the screws holding it to the enclosure.
VR61 and VR62 – 7
