14Operation of remote control unit

Loading batteries
1 Remove the cover.2 Insert batteries.3 Close the cover.

1

2

⎟Insert two R6 (“AA”-size) batteries following the polarity indications.

Preparation section

Operation

Plug the power cord into the mains power outlet and

press the on/standby ( POWER) key of the remote control unit to turn power ON. After the power has been turned ON, press the desired key.

Toturnpoweroff,presstheon/standby( POWER) key again.

The power mode enters the STANDBY mode in which the “STANDBY” indicator lights up. (The “TIMER” indicator also lights in this mode if a timer program has been activated.)

⎟When pressing more than one remote control key suc- cessively, press the keys securely by leaving an interval of 1 second or more between the key presses.

Operating

range

(approx.)

Remote

 

sensor

6m

30˚ 30˚

￿

1.The provided batteries are intended for use in operation checking, and their service life may be short. Notes 2.When the remote controllable distance becomes short, replace both of the batteries with new ones.

3.If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote sensor, malfunction may occur. In such a case, change the installation position to avoid malfunction.