Kenwood 4. Select the source to be recorded, 5.Start recording, Selection of the reverse mode, To pause recording (Main unit only), Let's record, 1Start recording

To pause recording (Main unit only)

REC/ARM Lights

T.EQ

A B

⎟Pressing the key pauses recording after leaving a non-recorded space of about 4 seconds.

⎟If the key is pressed again in less than 4 seconds after it has been pressed, recording resumes from that instant.

Let's record 29Selection of the reverse mode

REVERSE

MODE

Each press switches the modes as follows.

1“ ” .... Recording stops after having re-corded both sides of tape.2“ ” ... Recording stops after having re- corded both sides of tape.3“ ” ..... Recording stops after having re-corded one side of tape.

⎟When the “2” transport direction indicator is lit, recording always stops after having recorded one side of tape.

Select an input source other	4. Select the source to be recorded.
than “TAPE A or B”.
	Press the desired key.
	C D 0 1	1 : 1 2
	The input source component to
4	be recorded should be displayed.
	⎟ If a disc has already been loaded when the CD input is selected, it will starts
	to play automatically. In this case, press the stop (7) key to stop it.

⎟ When you select DVD/VIDEO (External input), adjust the input level. t

5.Start recording.

REC/ARM	1Start recording.
	2Play (or tune) the input source to be recorded.
5				⎟	If a disc has already been loaded
			Lights		when the CD input is selected, it
				⎟	will starts recording automatically.
					Even if deck A is selected, it is
			T.EQ		automatically switched to deck B
		A	B	⎟	at the start of recording.
					Recording stops automatically
					when the tape side(s) to be re-
				⎟	corded have been fully recorded.
					Press the stop (7) key of the cas-
					sette deck unit to stop recording
					(see the next page).

section Basic