56

Remote control unit

In case of difficulty

Symptom

 

Cause

 

Remedy

 

 

 

 

 

 

 

Remote control operation is

Batteries are exhausted.

Replace with new batteries.

$

not possible.

The remote control is too far away

Operate the unit within the remote

 

 

 

from the system, the controlling angle

 

controllable range.

 

 

 

is deviated or there is an obstacle in

 

 

 

 

 

between.

 

 

$

 

There is no tape or CD set in the

Set a tape or CD in the component to

 

 

 

component to be played.

 

be played.

 

 

An attempt is made to play the cas-

Wait until the recording ends.

 

 

 

sette deck which is recording some-

 

 

 

 

 

thing.

 

 

 

 

The MULTI CONTROL setting mode

Cancel the MULTI CONTROL setting

 

 

 

is activated.

 

mode.

%

 

 

 

 

 

 

General

Symptom

Cause

Remedy

 

 

 

 

 

No operation occurs when

The MULTI CONTROL setting mode

Cancel the MULTI CONTROL setting

 

an operation key is pressed.

is activated.

mode.

%

 

 

 

 

For the U.S.A.CAUTION :

Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

In compliance with Federal Regulations, following are reproductions of labels on, or inside the product relating to laser product safety.

KENWOOD CORPORATION 2967-3, ISHIKAWA-CHO,

HACHIOJI-SHI,TOKYO, JAPAN

KENWOOD CORP. CERTIFIES THIS EQUIPMENT CONFORMS TO DHHS REGULATIONS NO. 21 CFR 1040.10, CHAPTER 1, SUBCHAPTER J.

Location: Back Panel

Note to CATV system installer

This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical

Knowledge section

FCC WARNING

This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential instal- lation. This equipment may cause harmful interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

––Reorient or relocate the receiving antenna.

––Increase the separation between the equipment and receiver.

––Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

––Consult the dealer or an experienced radio / TV technician for help.