USA Assembly Instructions
Please bear in mind that there is always a danger of children injuring themselves while using swings, climbing frames, toy vehicles or similar equipment.
When riding the toy, the child should always wear covered footwear (no open toe shoes or barefoot riding).
When children are at play, situations may arise which cannot be predicted by the manufacturer and for which he cannot be held responsible.
Never use corrosive or abrasive substances to clean the toy. Never use substances which may cause pollution of the environment.
For models with air tires, check air pressure periodically (see tire for recommended psi). Due to the nature of materials used in air tires on Racer by Kettler® toys, it is not recommended that the product be left
in any one place for too long where solvents or other chemicals, i. e. petrol, may lie. This may result in a
chemical reaction, which could cause the tires to mark the surface such as a vinyl If in doubt put something underneath the wheels to cover
Lubricate the bearing sleeves of the wheels with a few drops of oil every two to three months.
Assembly of the Pedal Car
Please ensure that the vehicle will only be used for playing when assembly has been carried out cor- rectly, and checked, by an adult.
The toy vehicle must be assembled by an adult person. Study the assembly instructions carefully be- fore beginning work. Assemble the vehicle in the exact sequence shown by the letters in the diagrams. The vehicle will function as designed when correctly assembled.
Please note that there is always a danger of injury when working with tools or doing manual work. Therefore please be careful when assembling this machine.
Ensure that your working area is free of possible sources of danger, for example don’t leave any tools lying around. Always dispose of packaging material in such a way that it may not cause any danger.
There is always a risk of | if children play with plastic bags! | |
Bolt all the parts together loosely at | and check that they have been assembled correctly. Tighten | |
the locknuts by hand until resistance is felt, then use the wrench to tighten nuts completely against resistance (locking device). Then check that all screw connections have been tightened
rmly. Attention: once locknuts have been unscrewed they no longer function correctly (the locking device is destroyed), and must be replaced.
Please keep original packaging of this article, so that it may be used for transport at a later date, if necessary.
For technical reasons, we reserve the right to carry out preliminary assembly work (e.g. addition of tub- ing plugs).
When ordering spare parts, always state the full model number, spare part number, the quantity required and the serial number of the product.
Example order: model #
Important: spare part prices do not include fastening material; if fastening material (bolts, nuts, washers etc.) is required it should be clearly stated on the order by adding the words „with fastening material“.
3
