SECTION 1 Set-Up & First Brew
Ready to Brew Your First Cup (Continued)
12.The red Heating Light may be illuminated as the water is heated for the next brew cycle. The brewer will be ready for use in approximately 15 seconds. NOTE: During this period, your brewer will prepare for the next brew. The pump may make a vibrating sound. This is normal.
Stopping the Brew Process
If you need to stop the brewing after the process has started, press the Power Button to turn the brewer off. The flow of coffee, tea or hot cocoa
will stop, the heating element will shut off and the green Power Light will turn off. NOTE: You may get less coffee, tea or hot cocoa in your cup during your next brew. We recommend that you perform a cleansing brew after a terminated brew. Then your NEXT brew will be the proper volume.
Adding Water
The blue Add Water Light will illuminate when the water level in the Water Reservoir is low or if the
fig. 6 Water Reservoir has been removed (fig. 6). The brewer will not allow you to brew when the blue Add Water Light is illuminated.
The Water Reservoir can be filled in two ways.
1. Remove the Water Reservoir Lid and pour water directly into the Water Reservoir while it is still attached to the brewer. Fill with water to and not beyond the MAX FILL line. Replace the lid.
2. Remove the Water Reservoir from brewer by first removing the Lid from the Water Reservoir, then lifting the Water Reservoir straight up and away from brewer. Fill with water to and not beyond the MAX FILL line. Place the Water Reservoir back on the brewer and replace the Lid. IMPORTANT: Do not remove the Water Reservoir during the brewing process.
8
