set-up button continuously for more than 2 seconds, the digital will change quickly. If you don’t press the button in more than 5 seconds, the digital will stop flashing, set-up value will be memorized. This value will be shown when you restart next time.
During sauna session, set-up time will count down the minutes one by one. When the left time is 5 minutes, the equipment will make a warning sound for 15 seconds, at this moment, time display is flashing. During these 15 seconds, you can press any set-up button to stop warning sound, and reset up the time of new sauna session. If you don’t set up the time again, after 15seconds, sauna continues, when display time is 0, the equipment will power off automatically. Particularly the equipment will also power off if you don’t press any bottom in 5 minutes after you power on the sauna!
4. Switch between 0F and 0C
When power is on, “0C” and “0F” will switch when you press “0C/0F”. And the TEMPERATURE DISPLAY value will change accordingly.
5. Set up the heating temperature
When you turn the power on, press TEMPERATURE button “▲” or “▼” to increase or decrease the heating temperature of sauna room. The temperature will increase or decrease I minute when you press one time. If you press the set-up button continuously for more than 2 seconds, the digital will change quickly. This value will be the set-up sauna temperature. If you don’t press the button in more than 5 seconds, the digital will stop flashing, set-up value will be memorized. It will show this value when you restart the next time.
6. Start emitting or stop emitting
When powering the sauna on, press WORK START/STOP button one time, WORK and HEAT light is on, the emitters will start emitting. (If you press this button again, emitters are off, WORK and HEAT light is off.) In the summer (room temperature is around 300C/860F), (such as 2 person sauna) heating time and actual inside temperature like the following datasheet:
actual inside temperature | 400C(1040F) | 500C(1220F) | 550C(1310F) | 600C(1400F) | 660C(150.80F) |
Heating time (minutes) | 5~7 | 17~19 | 23~25 | 31~33 | 43~45 |
When environmental temperature is low, heating requires additional time. The above data is only for your reference. When the temperature is at the set-up value, the digital control will maintain the set temperature. The WORK light will remain on and the HEAT light will turn off. When the top heating, the sauna will maintain the set-up temperature for some time, when the inside temperature drops 20C, the digital control will make the emitters continue heating until it reaches the set-up value. With the digital control, the inside sauna temperature is always around the set-up value.
7. Inside reading lamp switch
1)Press the light ON/OFF button one time to switch on, press again to switch off.
