Assembly
FIGURE 5
Step 1:
Insert the tension cable (45) into the upright tube (42) and pull it out from the open- ing on the upright tube (42). Connect the sensor wire (40) on the main frame with the extension wire (41) on the upright tube (42). Insert the upright tube (42) into the main frame and secure it with by screws (18) and arc washers (4).
FIGURE 6
Step 1:
Get the tension cable (45) out of the opening on the handle- bar post hole, and connect it to
Figure 5
45
| 42 |
41 |
|
40 | 45 |
18 | |
4 |
|
18 | 18 | |
4 | ||
|
Figure 6
A B
the tension controller (44) as step
45
45
Step 2:
Put the cable end (44) into the spring hook (45).
Step 3:
Pull the knob and force the short cable (44) into the gap of the bracket (45).
Step 4:
Insert the tension knob (44) into the handlebar post (42), and secure with screw (43) attached.
Note: Tension is increased by turning the knob clockwise.
44 | 44 | 45 |
| ||
|
| 43 |
44
42
