
Assembly
NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.
Attach the Backrest Board (3) to the Backrest Support (8) using four Washers (B2) and four Bolts (A5).
Push two Bushings (24) into Leg
Developer (12). Install the Leg
Developer (12) onto the Main
Frame with one Bolt (A4), two
Washers (B1) and one Aircraft
Nut (C1).
Insert two Roller Foam Tubes
(10)halfway onto Leg Developer. Push Foam Rollers (25) on each side of the Roller Foam Tube to complete Leg Developer Assembly.
Repeat this step to place Foam Roller onto Main Frame.
8