Format New HDD in Windows 98SE / ME | Keyspan SX-18D specification

- Press [ESC] to exit fdisk, you must then Reboot the computer.

5.7Format New HDD in Windows 98SE / ME

- You must reboot the computer after perform fdisk. Ensure the

new HDD is enumerated and the OS will assigned a letter to the new HDD.

-Reboot the computer again once the computer has successfully detected the new HDD before formatting it,

-Click on the new Local Disk (L:) icon by right-button mouse,

-Select the Format option.

User Manual

18

Image 22

Keyspan SX-18D user manual Format New HDD in Windows 98SE / ME

Contents

Model SX-18D Page Table of Content Page Introduction Functional Description ConnectorsLED Indication Product Dimension Product SpecificationsElectrical Specifications Minimum System Requirement Bundled Accessories User Interface Description Button Description 2 SD/MMC/MS/SMC Memory Card Slot Slot #1 Mini USB connectorCompact Flash Memory Card Slot Slot #2 4 44-pin Connector Battery Compartment Standalone Mode Copy Device Operation USB mode Install Device Driver on Windows 98 SE / ME Chatper 5 Windows 98SE/ME InstallationOperating System Supported Page Verify Win98SE/ ME has properly installed the device driver Troubleshoot Installing New HDD on Windows 98SE / ME Configure new hard disk in Win98SE / ME Check that Instep EzII DRIVE0 is present Page Page Page Format New HDD in Windows 98SE / ME Page Windows 200x / XP Installation Verify windows has properly installed the device driver Create Master Boot Record on the new hard disk Click the Disk Management iconPage Create Primary Partition Record on the new hard disk