Installation
Remote Bass Level
When the crossover on your KX series amplifier is set to LOW PASS, you have the ability to control the output level of the amplifier from the driver’s seat using the supplied Remote Bass Level Control.
To mount the controller simply screw the metal bracket to the chosen location, then slide the housing onto the bracket until it snaps into place.
Run the cable from the controller to the “Remote Bass” jack on the amplifier chassis.
BACK VIEW
Mounting Surface
SIDE VIEW
PHONE
CABLE
USING THE SIGNAL OUTPUT JACKS (PAST)
The Output (Pre Amp Signal Transfer) RCA jacks allow you to send the incoming signal from one Kicker KX series amplifier to another amplifier or processor without the need for Y cables. The signal from the PAST jacks is identical to the signal fed to the amplifier via its RCA input jacks or the High Level inputs and is not affected by the amplifier’s built in crossover.
Most head units with high voltage outputs should be capable of driving up to ten amplifiers in a chain.
WARNING - Use either the
| Speaker | |
Left + | Outputs | |
Left - |
| |
Right - | SOURCE UNIT | |
Right + | RCA | |
Outputs | ||
|
To Next Amplifier or Processor
6 | KX AMPLIFIERS |
