Operation, Normal Operating Characteristics | Kidde KN-COPP-3-RC

Operation

Normal Operating Characteristics

When you first power up the unit, the alarm will sound briefly to let you know the unit is receiving power and that the alarm circuit is functioning.

You will see three eights on the digital display, indicating the alarm is in the start-up mode. The three eights will remain for approximately 20 seconds. You will see a blinking red dot to the lower right of the digital display. The blinking dot shows that the alarm is operating.

Blinking Dot

Within 20 seconds, your CO alarm will start monitoring for CO. The num- ber indicates a measurement of carbon monoxide in parts per million (ppm). Note: The number will probably be zero (0). This is a normal con- dition for most households and shows that no measurable amount of CO has been detected.

The alarm has begun monitoring the air for carbon monoxide and will con- tinue to do so as long as it receives power.

15

Image 19

Kidde KN-COPP-3-RC manual Operation, Normal Operating Characteristics

Contents

Carbon Monoxide Table of Contents Page Setting up your alarm for first time operation Quick Set Up Guide Quick Set Up Guide Introduction Carrier CO Alarm front view Features Digital Display Pull-Out Transformer/Adapter Rear view with back door removed What Carbon Monoxide Alarms Can and Cannot Do Where to Install Your CO Alarm InstallationRecommended Locations AT Least 5 feet away from appliance Where Not to Install Your CO Alarm Avoid the following How to Install Your AlarmDirect Plug Alarm To install To rotate the adapter Wall Mounted AlarmPlug the alarm into an unswitched wall socket If the outlet is mounted horizontally sideways Or drywall, drill a 3/16 hole into the wall Table Top AlarmWall Battery Installation and Operation Battery Installation Battery Back-up Operation inTrouble Alarm Condition Battery Backup OperationBattery Backup Operation Battery Back-up Operation in Low Battery Lb ConditionPage Operation Normal Operating Characteristics Testing the Electronics What to do if you’re not sure If the alarm malfunctionsMalfunction Signal Group 1 Component Failure Malfunction Signal Group 2 Microprocessor Failure Alarm from the electrical outlet before vacuuming How to Care for Your Alarm Peak Level Memory To Reset the Peak Level Memory… Never use a gas range, oven, or clothes dryer for heating Home Safety Tips What You Can DoCarbon Monoxide What You Should Not Do Clues You Cannot See Loose or disconnected vent/chimney, fireplace or applianceUnderstand the Effects of Carbon Monoxide Exposure Common Extreme Exposure Symptoms What To Do When the Alarm SoundsCommon Mild Exposure Symptoms Common Medium Exposure Symptoms Call your emergency services If alarm signal sounds 4 quick chirps, 5 seconds offTion Specifications How the Unit Determines When to Alarm SpecificationsReplacement of Alarm Display Readings AC and DC Start Up, Alarm and Error Operation DC Powered in Battery Backup Operation AC Powered in Normal Stand-by Operation Detect CO Li-Ion Battery Handling Precautions Battery Storage When Detached From the Alarm Limited Warranty Please send products and all other correspondence to For Warranty Service