Kidde P/N 900-0120, KN-COB-IC specifications Battery Replacement If Equipped, Alarm Removal

Battery Replacement (If Equipped)

Alarm Removal

If tamper resist feature has been activated, refer to tamper resist feature description on page 10 for removal instructions.

Remove the alarm from the mounting plate by rotating the alarm in the direction of the “OFF” arrow on the cover. To disconnect the AC Quick-Connector harness, squeeze the locking arms on the sides while pulling the connector away from the bottom of the alarm (see Figure 2).

FOR ALARMS EQUIPPED WITH 9 VOLT BATTERY BACKUP

After the alarm has been removed, you can open the battery door and replace the battery. Battery installation instructions are provided on the inside of the battery door.

When installing the battery, orient the battery as shown on unit label. Press the battery reminder tab down into the battery compartment and install the battery (see Figure 4).

FIGURE 4 BATTERY REPLACEMENT

Battery

tab

CAUTION! If the battery reminder tab is not held down in the battery compartment by the battery, the battery door will not close, the AC Quick-Connector will not attach to the alarm, and the alarm will not attach to the mounting plate.

After installing or changing the battery, reinstall your alarm. Test your alarm by using the Test/Reset button and check that the green “Power” LED is on.

1 6