Cleaning POOL FROG® Mineral Hybrid Cell
Our clear cell allows for easy regular inspections for calcium build up. Visually check the cell periodically, and clean it as necessary (1 to 2 times per year). Advanced
Do not use metal or other hard objects to clean the cell as this could scratch the precious coating on the plates and void the warranty.
CAUTION: Always add acid to water, NOT water to acid. Diluted muriatic acid solution = 10 parts water to 1 part acid. Note: Follow the instructions of the acid manufacturer.
CAUTION: Always use protective eyewear and protective clothing.Cleaning With Optional Cleaning Cap:1.Before removing cell, turn off power to pump and control panel of generator. Make sure to note in which direction the cell was installed so it can be replaced correctly.
2.Remove the cell from the line by undoing the electrical connections from the cell and the barrel unions from the cell ends.
3.Remove the black
the ends of the cell.
4.Attach the cell Cleaning Cap to one end of cell.
5.Put on rubber gloves and goggles.
6.Pour into cell, either undiluted white distilled vinegar, or a solution of diluted muriatic acid (10 parts water to 1 part muriatic acid).
7.Wait for foaming to stop
8.Safely dispose of muratic acid by pouring it into your pool only. If using vinegar dispose of by pouring down your kitchen drain.
9.Rinse cell with water hose. Avoid contact with skin or clothes.
10.Put the
back in place and
11.Reconnect the electrical wires, being sure to tighten
the screws on the electrical wires firmly. See cell wiring diagram.1.Remove the cell from the line by undoing the electrical connections from the cell and the barrel unions from the cell ends.
2.Remove the black
3.Put on rubber gloves and goggles.
4.Soak entire cell either in undiluted white distilled vinegar or in a solution of diluted muriatic acid (10 parts water to 1 part muriatic acid).
5.Wait for foaming to stop
muratic acid – vinegar takes longer).
6.Safely dispose of muratic acid by pouring it into your pool only. If using vinegar dispose of by pouring down your kitchen drain.
7.Rinse cell with water hose. Avoid contact with skin or clothes.
8.Put the
9.Reconnect the electrical wires, being sure to tighten the screws on the electrical wires firmly. See cell wiring diagram.
CELL WIRING DIAGRAM
Optional1.Lubricating the
2.Smear the two electrical connections on the outside of the cell with electrical lubricant.
Control Panel MaintenanceThere is no regular maintenance required on the control panel other than checking that the wiring running from the control panel to the cell and flow sensor is securely in place. It is beneficial to keep the control panel clean, dry and out of the sun.
11