18 | Appendix D Mounting Templates |
The EtheRx WorkGroup hubs can be stationed on a flat surface using the four rubber feet provided, or mounted vertically by using the mounting holes on the bottom side of the unit. The illustrations below detail the measurements and mounting holes and rubber feet locations. They are drawn to scale, although not actual size.
5.95"
Front Panel
Rubber Feet |
1.08" |
Wall Mount Holes |
4.28" |
Rubber Feet |
Rear Panel
6.44"
2.95"
5.95"
Front Panel
Rubber Feet
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions.
(1) This device may not cause harmful interference, and | Models: | |
KNE4TX/WG | ||
(2) This device must accept any interference received; | KNE8TX/WG | |
including interference that may cause undesired |
| |
operation. |
|
|
Operation & Configuration Instructions | ||
UTP PORT STATUS LEDs |
| |
SOLID GREEN | Good link is established |
|
FLASH GREEN | Data is being received |
|
FLASH AMBER | 1. Port is partitioned due to excessive collisions, or | |
| 2. Port has encountered errors due to invalid packets or | |
| jabber condition |
|
COLLISION STATUS LED |
| |
FLASH AMBER | Collision is detected |
|
UTILIZATION STATUS LEDs |
| |
SOLID GREEN | Network traffic rate is displayed in percentage | |
For more detailed information, please refer to the User's Guide provided.
Rubber Feet 
Rear Panel
6.44"
2.95"
Fig. E-1 Mounting Template specifications
Kingston Technology Company | KNExTX/WG User’s Guide - Rev. A00 |
