KitchenAid 2004022 Door swing dimensions, Anti-tip requirements, Tipping radius

Door swing dimensions

B
1
A	Top front
of	refrigerator	Location must permit	doors to	open
		to 90” min. Allow 1 inch (2.5 cm)
		min. space between	refrigerator	side
		and corner wall.

Anti-tip requirements

Tipping radius

_____-------____

Forward/backward _x-xT-*-- tipping radius ,,1-’

III’ #’,’

r’I

I

I’

I’

__--_------_

l/4” (6 mm) ma,

2” (5 cm) min.

Two 2” x 4” x 32” (5 cm x

*lOcmx81 cm) anti-tip wood boards

Attach to wall studs with six, #8 x 3” (76 mm) (or longer) wood screws.

Boards must be

-long enough to fully cover width of compressor cover.

Side			*’
tipping radius		/ / / ,/l’-	e3l
// /	/ /

/I

/

I

I

V-B-

87-l /4” (222 cm) 90-l /2” (230 cm)

Page 4

+ rear wall

II 44

If boards are placed before installation of refrigerator, locate boards so the bottom surface of the boards are 84 inches (213 cm) from the floor. During installation, raise the refrigerator up so there is l/4 inch (6 mm) maximum between top of refrigerator and bottom of anti-tip boards.

If solid soffit is 1 inch (2.5 cm) above

refrigerator, anti-tip wood boards are not required.

If solid soffit is not available or soffit is more than 1 inch (2.5 cm) above cover, center wood boards on rear wall l/4 inch (6 mm) maximum above refrigerator. Attach wood boards to wall studs with wood screws - making sure that screws are engaged in wall studs l-l /2 inch (3.8 cm) minimum and that boards extend 2 inches (5 cm) minimum over the top rear of refrigerator compressor cover.