Parts supplied for ins:allation:
l base grille
l miscellaneous parts bag
Check
|
| Product/Property |
|
| Damage |
| ||||||
l Do Not lower the refrigerator |
| |||||||||||
| against |
|
| the | shipping |
| base | when | ||||
| removing |
| the shipping | base. |
| |||||||
l | Do | Not |
| remove |
| protective | film | |||||
| until |
| refrigerator |
| is in | operating |
| |||||
| position. |
|
|
|
|
|
|
|
|
| ||
l | All | four |
| leveling |
| legs |
| must |
|
| ||
| contact |
|
| the | floor | to | support | and | ||||
| stabilize |
| the | full |
| weight | of | the |
| |||
| refrigerator. |
|
|
|
|
|
|
| ||||
l | Keep | cardboard |
| shipping | piece | |||||||
| or plywood | under | refrigerator |
| ||||||||
| until |
| it | is installed | in | operating |
| |||||
| position. |
|
|
|
|
|
|
|
|
| ||
Failure | to | follow | these instructions | |||||||||
may | cause | damage |
| to | product | olr | ||||||
floor | covering. |
|
|
|
|
|
|
| ||||
Remove and save literature
1. package and parts bag taped to refrigerator door. Remove four brackets (two on each side) attaching shipping base to refrigerator bottorn. Do Not remove tape and door bracing until product is secured in final location. See Page 3.
Personal Injury Hazard
l Because of the weight and size of
the refrigerator, two or more people are required to install it.
l Most of the refrigerator’s weight is at the top. Extra care is needed
when moving the refrigerator to prevent tipping.
Failure to follow these instructions could result in personal injury.
Place sections of shipping carton 3 . on the floor when rolling dolly and refrigerator into the house. Move refrigerator close to
4
Set*power switc at top of cabinet to “OFF” position. Plug power supply cord into grounded outlet. Install retainer on grounded outlet using screw from parts bag.
Place top of cardboard
5 . carton or plywood under refrigerator. Remove dolly. Open appliance doors and remove all boxes, parts packages and packing materials from refrigerator and freezer
compartments. Do Not remove protective film.
Move the refrigerator straight back and evenly into the opening. Check that:
l copper tubing is not kinked.
l power supply cord is on top of refrigerator next to cover.
corner of
I |
| \\ | I |
| (6 mm) | Ye |
|
l/4” (6 mm) | l/4” | (6 mm) | |
compression | union | compression | |
nut |
|
| nut |
I | l/4” | I |
|
| (6 mm) |
|
|
| sleeve |
|
|
Slide a compression nut and sleeve on open end of each copper line. Use a copper tubing union to connect both copper lines. Do Not overtighten.
Turn water supply valve to “OPEN” position. Turn refrigerator switch “ON.” Wait a few minutes. Check water line connection and water valve on top of cabinet for leaks. Without kinking the tubing, carefully place it back underneath cabinet.
Insert carton corner posts between strap and refrigerator at side trim pieces and handles. Carefully tighten strap making sure side trim and handles are protected.
Paae 8
Check that water supply line has been flushed. See Page 7.
Pull copper line from refrigerator 6 . water valve and copper line from plumbing forward from underneath refrigerator. Remove cap from water line.
