4
Overlay Frame Rear ViewRear view of overlay frame shows right-hand hinge. Mirror the
image for left-hand hinges. See “Pivot Plate Relief” for additional
dimensions.
Overlay Frame Top ViewPivot Plate Relief1. Route the top and back of the overlay frame to create the
pivot plate relief as shown.
2. Drill two screw holes in the back of the pivot plate relief as
shown.
Door Hinge Holes1. Using a #16 drill bit, drill an ¹¹⁄₁₆" (1.75 cm) deep hole into the
top of the overlay frame for the top hinge pin as shown.
2. Drill a ⁵⁄₁₆" diam x ¹⁄₄" deep (7.94 mm x 6.35 mm) hole in the
bottom of the overlay frame for the bottom hinge as shown
NOTE: CHAMFER: ¹⁄₃₂" (0.79 mm) x 45°.
A.Pivot plate reliefA
21¹⁄₂"
(54.6 cm)
23³⁄₄"
(60.3 cm)
27³⁄₄"
(70.5 cm)
30"
(76.2 cm)
21¹⁄₂"
(54.6 cm)
23³⁄₄"
(60.3 cm)
³⁄₄"
(1.91 cm)
2
¹⁄₄"
(5.72 cm)
1
¹³⁄₁₆"
(4.60 cm)
1
¹⁄₈"
(2.86 cm)
⁵⁄₃₂"
(3.97 mm)
³⁄₈"
(9.53 mm)
¹¹⁄₁₆"
(1.75 cm)
⁷⁄₁₆"
(11.11 mm)
Side View Back View
A.⁵⁄₁₆" diam. x ¹⁄₂" deep (7.94 mm x 1.25cm)Top View
A.Top hinge-pin holeBottom View
A.Bottom hinge-pin hole¹⁄₈
"
(3.18 mm) R ¹⁄₃₂"
(0.79 mm)
¹³⁄₁₆"
(2.06 cm)
R ¹⁄₈
"
(3.18 mm)
A
¹⁄₈
"
(3.18 mm)
¹³⁄₁₆"
(2.06 cm)
⁷⁄₁₆"
(11.11 mm)
¹³⁄₃₂"
(10.32 mm)
1¹⁷⁄₃₂"
(3.89 cm)
³⁄₄"
(1.91 cm)
¹³⁄₃₂"
(10.32 mm)
³⁄₈"
(9.53 mm)