8

Door Closing

Door Closing

Your wine cellar has four leveling legs. If your wine cellar seems
unsteady or you want the door to close more easily, adjust the
wine cellar’s tilt using the instructions below.
1. Plug into a grounded 3 prong outlet.
2. Move the wine cellar into its final location.
3. Turn the leveling legs to the right to lower the wine cellar or
turn the leveling legs to the left to raise it. It may take several
turns of the leveling legs to adjust the tilt of the wine cellar.
NOTE: Having someone push against the top of the wine
cellar takes some weight off the leveling legs. This makes it
easier to adjust the leveling legs.
4. Open the door and check to make sure that it closes as easily
as you like. If not, tilt the wine cellar slightly more to the rear
by turning both front leveling screws to the right. It may take
several more turns, and you should turn both leveling legs the
same amount.

Base Grille

Remove the Base Grille:

1. Open the wine cellar door.
2. Using a Phillips screwdriver, remove the three screws
attaching the base grille to the wine cellar.
3. Pull the base grille toward you.

Replace the Base Grille:

1. Open the wine cellar door.
2. Position the base grille so that the holes are aligned and
replace the three screws.
WINE CELLAR USE

Normal Sounds

Your new wine cellar may make sounds that your old one didn’t
make. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal. Hard
surfaces, such as the flooring and surrounding structures, can
make the sounds seem louder. The following desc ribes the kinds
of sounds and what may be making them.
■Your wine cellar is designed to run more efficiently to keep
your food items at the desired temperatures and to minimize
energy usage. The high efficiency compressor and fans may
cause your wine cellar to run longer than your old one. You
may also hear a pulsating or high-pitched sound from the
compressor or fans adjusting to optimize performance.
■Rattling noises may come from the flow of refrigerant or items
stored inside the wine cellar.
■As each cycle ends, you may hear a gurgling sound due to
the refrigerant flowing in your wine cellar.
■You may hear water running into the drain pan when the wine
cellar is defrosting.
■You may hear clicking sounds when the wine cellar starts or
stops running.

Using the Control

For your convenience, your wine cellar control is preset at the
factory. When you first install your wine cellar, make sure that the
control is still preset to the mid-setting as shown.

Adjusting Controls

The mid-setting indicated in the previous section should be
correct for normal usage. The control is set correctly when
beverages are as cold as you like.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
WARNING
Excessive Weight Hazard
Use two or more people to move and install wine cellar.
Failure to do so can result in back or other injury.
A. Screws
A
A
A