KitchenAid 3184330 installation instructions Panel D, Numbers correspond to steps

Models: 3184330

1 7
Download 7 pages 23.21 Kb
Page 5
Image 5
Numbers correspond to steps.

Numbers correspond to steps.

111ITurn saddle valve handle clockwise ’ until lance pierces soft copper tubing

uand valve is firmly seated: The valve is now in the closed position. Place a bucket under open end of water supply line. Turn on main water supply valve to pressurize cold water line. Check for leaks. Use a wrench to tighten nut/seal around valve stem.

Open saddle valve and flush line into bucket to remove any foreign material that may have been trapped

n the suppl lY line during saddle valve installation. Close sadd le valve.

tubing

faiket

saddle

II valve

rl13 Connect water supply line from

n saddle valve to shorter copper tubing

12 from the faucet using the compression union. Open saddle valve.

Product Damage

Do Not remove internal stainless steel filter screen from the compression fitting.

Failure to follow this instruction could result in damage to the valve.

Fill tank with water and turn thermostat to “OFF” position before plugging hot water dispenser into power supply.

Failure to do so could cause hot water dispenser heater to overheat resulting in an unpleasant taste, black specks in water, and permanent damage to the heater seals.

green tape

I4n

Push or pull faucet

lever to open

BIcm

position. Hold lever

in open position

I1 until tank is full (approximately 1 minute)len. tank is full. water will flow from faucet spout. Release lever to close faucet. Check for leaks.

115ITurn thermostat knob counter-

= clockwise to “OFF’ position. Plug

1 1power supply cord into properly grounded outlet. Turn thermostat knob clockwise to highest position. Water in tank will reach maximum temperature in approximately 15 minutes and dispenser will be ready for use. Lower temperature setting if you notice vapor or hear boiling noise.

NOTE: Thermostat controls tank heater, not water delivery. Rotate thermostat knob clockwise to raise water temperature; counterclockwise to lower water temperature.

To get the most efficient use from your new hot water dispenser, read the Use & Care Information. Keep Ins talla tion lnstruc tions4Jse & Care Guide close to hot water dispenser for easy reference.

Panel D

Page 5
Image 5
KitchenAid 3184330 installation instructions Panel D, Numbers correspond to steps