11
4. Place the top half of the connector box on each and screw
the 2 halves together using the 4 screws provided for each
connector box.
5. Using the 2 longer screws provided for each box, attach the
assembled connector boxes to the metal flange.
Install Non-vented (recirculating)Range Hood
1. For recirculating installations only, install charcoal filter from
Non-vented (recirculating) Chimney Kit behind the center
grease filter by inserting and locking it in place.
2. Install grease filters using 2 hands by first pulling and turning
the knob to the left so that the locking lever does not protrude
from the filter.
3. Insert the opposite end of the filter into the retaining channel.
4. Insert knob end and turn knob to the right to lock the filter
into place.
5. Repeat for remaining filters.
6. Reconnect power.
Complete Installation

Check Range Hood Operation

1. Press the light button (F) to turn on the light, press again to
turn light off.
2. Press the night light button (G) to turn off the night light, press
again to turn night light off.
3. Press the On/Off button (A) to turn the fan on. The speed
setting will appear in the display.
4. Press the “+” or “-” minus buttons to increase or decrease
the fan speed.
5. Press the On/Off button (A) to turn off the fan.
6. If range hood does not operate, check to see whether a
circuit breaker has tripped or a household fuse has bl own.
NOTE: To get the most efficient use from your new range hood,
read the “Range Hood Use” section.
A.Screws
B.Connector box half
A
B
B
A.Locking lever slot
B.Retaining channel
C.Knob
A.Fan motor on/off
B.Decrease fan motor speed
C.Increase fan motor speed
D.Electronic Display
E.10 minute timed boost
F. Lig h t
G.Night light

A

BC

ABCDEFG