FOR THE PLUMBER

. CONNECT TO WATER . CONDENSATE PUMP

(observe local codes)
1
Use l/4” (6 mm) OD soft copper tubing for the cold
water supply.
2 Provide a convenient manual shut-off valve in the
water line.
3 Position the t b’
u rng so it can enter the access hole
located in the right-hand rear of the cabinet. The
tubing should extend beyond the cabinet front
when the cabinet is pushed back into position. See
Figure 5.
1
When drain connection below the level of the unit
is not available a condensate pump may be used to
lift the water to an available drain.
2 Install condensate pump on floor behind ice maker
with discharge tube to the rear. Run drain bin directly
into pump as shown in Figure 5A.
3 Run power cord through hole into unit compartment.
(See Figure 5A)
4 Remove lower grille assembly. (See Figure 58)
5 Remove shunt from receptable and plug in conden-
sate pump. (See Figure 5C)
NOTE:
Always purge the water line before making the final
connection to the inlet of the water valve to prevent
possible water valve malfunction. Do not discard shunt that is removed from
After the cabinet is in place, bend the tubing to meet
the connection at the water valve. The garden hose
threaded compression fitting is found in the parts
bag. This joint provides a convenient disconnect for
service. Be sure the tubing is clear of compressor,
to prevent rattle.
CONDENSATE PUMP HAS I
~~ ~~ ‘RESSURE
SWITCH THAT CYCLES ITS PUMP.

. CONNECT THE DRAIN

(observe local codes)
1
The unit is provided with a gravity drain.
2 The ideal installation has a standpipe l-1/4” (32 mm
minimum) installed directly below the outlet of the drain
tube. Refer to Figure 5 for the proper location of
the standpipe.
3 It may be desirable to insulate drain line thoroughly
up to drain inlet.
ADD PLASTIC HOSE
FROM BIN DRAIN

I \

THROIIGH THIS HOLE
ACK VIEW IE 5 I
RlGHT END VIEW B>
4,“” IC m-1 n n
1,v ,” 11,111, V.Y.
WATER LINE
COMPRESSION 4 I.D. RUBBER DRAIN TUBE - RUN
TO OPEN DRAIN
l-1/4” MINIMUM
(32 mm MINIMUM)
HOLE FOR FIELD
BEND FIELD SUPPLIED WATER LINE
TO CONNECT TO WATER VALVE FITTING