KitchenAid 4KUIS185S manual HOW IT Works, HOWEVER, is not Recommended

eleCtriCal inspector), a temporary adaptor may be plugged into the existing 2-prong wall receptacle to mate with the Bprong power supply cord. See Figure 7. THIS,

HOWEVER, IS NOT RECOMMENDED.

NOTE: If this is done, you must connect the grounding eyelet on the adapter to the wall receptacle cover plate screw and from this same screw, you must connect a separate copper ground wire (No. 4 minimum) to a grounded cold water pipe*. See Figure 7. Do not ground to a gas supply pipe. Do not connect to electrical supply until appliance is permanently grounded.

*Cold water pipe must have metal continuity to electrical ground and not be interrupted by plastic, rubber or other electrically insulating connectors (including water meter or pump) without adding a jumper wire at these connections.

GROUND ASSEMBLY (ATTACH TO GROUNDED COLD IlWTER PIPE)

					\
GROUND		CLAMP		ELECTRICALLY
\ MUST BE		TIGHT
				GROUNDEDCOLD
ON	PIPE.’
				WATER	PIPE (REMOVE
				PAINT,	etc.)
GROUND	WIRE	(6’4			I
			GROUNDING
			EYELET	=2
	SCREW			il
3-PRONG			1
GROUNDING
PLUG				0..a
				0
					f
				uWAL .L RECEPTACLE
POWER	SUPPLY	CORD

FIGURE 7

HOW IT

WORKS

0 Compressor runs

0Condenser fan runs

0Water pump runs (circulates water)

0Cutter grid is warm to touch

WHEN THE DESIRED ICE SLAB THICKNESS IS REACHED, THE HARVEST CYCLE BEGINS AND THE FOLLOWING HAPPENS:

0Evaporator thermostat is satisfied

0Compressor keeps running

0Condenser fan stops or turns very slowly

0Water pump stops

0Hot gas solenoid opens

0Water inlet valve opens

0Excess water is flushed out of the drain pan l Cutter grid is warm to the touch

NOTE: Normal harvest cycle takes 60 to 120 seconds.

MACHINE RESUMES FREEZING AFTER SLAB IS RELEASED FROM EVAPORATOR AND THE CUTTING PROCESS BEGINS.

WHEN THE STORAGE BIN PSFILLED, BIN THERMOSTAT OPENS.

0 Cutter grid remains on

6