WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect
Reconnect the
Failure to follow these instructions can result in death or serious burns to children and adults.
line | wall stud |
|
bracketmounting
WARNING
Electrical Shock Hazard Disconnect power before servicing. Use 8 gauge copper wire. Electrically ground range.
Failure to follow these instructions can result in death, fire, or electrical shock.
This range must be connected to a grounded, metallic permanent wiring system or a ground connector should be connected to the ground terminal or wire lead on the range.
This range is manufactured with a frame- connected, green or bare ground wire
3.Connect the two black wires together; and the two red wires together using
4.Separate the
5.Connect the two white wires together using
6.Connect the bare ground wire from the range cable to the grounded wire in the junction box or other grounded connector using
7B. Where local codes permit connecting the
junction power supply box
screws
wire. Connect the range cable to the junction box through the U.L.- or CSA- listed conduit connector. Complete
red wires
black wires
6. Position top of
NOTE:
electrical connection according to local codes and ordinances.
7A. Where local codes Do Not permit connecting the
white wire
white and bare grounding oven cable wires — factory crimped
U.L.- or CSA- listed conduit connector
7. Make electrical connection.
If your house has aluminum wiring, see “Electrical requirements” page 5.
|
| junction box | ||
red wires |
| |||
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
| white wires | |
|
|
|
|
|
bare or green | black wires |
wires |
|
|
Grounded neutral
Figure 2
1. | Disconnect power supply. |
2. | Connect the flexible, armored cable |
| from the range to the junction box |
| using a U.L.- or |
| connector. Tighten screws on conduit |
| connector. |
3. Connect the two black wires together; | |
| the two red wires together; and the |
|
U.L.- or CSA- listed conduit connector
cooktop cable wires to the white |
(neutral) wire in the junction box using |
6
Ungrounded neutral
Figure 1
1.Disconnect power supply.
2.Connect the flexible, armored cable from the range to the junction box using a U.L.- or