8. Remove cardboard or hardboard from under range.
3 front screws
(4 rear screws required
but not shown)
attaching the
backguard
use
compound manual gas
shutoff valve
regulatorflexible connector
1/2" flare union | 1/2" to 3/4" gas |
adapter | pipe |
a 1/2" male pipe thread is needed for connection to pressure regulator female pipe threads
11. Make gas connection. Assemble flexible connector from gas supply pipe to pressure regulator located in the middle front of the range. Apply
| burner cap | |
ignitor | burner | |
electrode | ||
base | ||
|
gas tube opening
14. Put a burner cap on each burner base. Place burner grates over burner bases and caps.
If your model has only surface burners (no grille or griddle), go to “Check the operation of the surface burners, grille and griddle” on Page 9.
If your model was shipped with a grille or griddle, go to “Installing the grille or griddle” on Page 8 to complete the installation.
attaching the island
trim
center hole
not used
9. Attach the backguard or island trim as required for your installation. Attachment screws are in the literature package.
10. Slide range completely back so
shutoff valve “open” position
gas supply line
to range
12. Open manual shutoff valve in gas supply line. Wait a few minutes for gas to move through the line.
13. Leak testing of the appliance shall be conducted according to the following instructions:
Use a brush and liquid detergent to test all gas connections for leaks. Bubbles around connections will indicate a leak. If a leak appears, shut off gas valve controls and adjust connections. Then check connections again. Clean all detergent solution from range.
15.Turn on power supply. “PF” should appear in the clock display. (Refer to your Use and Care Guide for instructions on using the electronic control.)
7
