3.Hold the two panels together and push them up against dishwasher leg and vinyl pad.
4.Reinstall the screws through the holes in the access panel and the slots in the lower panel. Install right side screw first.
5.Check that the lower edge of the lower panel contacts the floor.
6.Tighten the screws.
Direct wire method:
WARNING
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector in terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
Power supply cord method:
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
7.Reconnect power or plug in dishwasher.
Check operation
1.Read the Use and Care Guide that came with your dishwasher.
2.Check that all parts have been installed and no steps were skipped.
3.Check that you have all the tools you used.
4.Start dishwasher and allow it to complete the shortest wash cycle. After the first two minutes, unlatch door, wait five seconds, then open door.
5.Check to see that there is water in the bottom of the dishwasher tub. Check that dishwasher is working properly. If not, see “If dishwasher does not operate” section.
6.Disconnect power or unplug dishwasher.
If dishwasher does not operate
First try the solutions suggested here to possibly avoid the cost of a service call.
•Has the circuit breaker tripped or the house fuse blown?
•Is the door closed tightly and latched?
•Has the cycle been set correctly to start the dishwasher?
•Is the water turned on?
If none of these work, call
21
