Electrical Shock Hazard
l Disconnect electrical power at the service panel (fuse box or circuit box).
l Make sure that the water supply line, drain line and wiring do not touch any exposed terminals of the dishwasher wiring.
Failure to do so could result in serious injury or death.
Cut a
wiring to pass through. If this hole is cut in a wood cabinet, the hole should be sanded until smooth. If the hole is cut in a metal cabinet, the hole must be covered by $I grommet (Part No. 302797). Run flexible cable from fused disconnect, circuit breaker or junction box through hole in cabinet. Cable should extend 24” from back wall.
Remove the 2 screws below the access panel. Pull
bottom of panel out and lifl up and away from dishwasher. Set access panel aside on a protective covering.
13.
Numbers correspond to steps.
w
The dishwasherdiz’’ is’ shipped’’
I to be installedir in a 34” cabinet opening. Mea:Measure height of
cabinet opening from undersideI of countertop to floor. Adjust leveling legs to required openiropening height.
8.
18.
Floor Damage Slide dishwasher onto cardboard or hardboard before moving across floor. Failure to do so may cause damage to floor covering.
Place drain hose on the left side of the cabinet opening
between the motor and the frame. Latch dishwasher door. Grasp dishwasher by the door frame and push the dishwasher into the cabinet opening. Be careful not to oush on the dishwasher panels. Ce’nter dishwasher in cabinet opening. Check that front leveling legs are firmly against the floor.
Page 5
