&tom-made panels
Personal Injury Hazard
Handle metal edges of panels carefully. Cut metal edges may cause personal injury or damage to other materials.
Product Damage
Heavy duty door springs must be used with custom panels that weigh more than four pounds.
Failure to follow this instruction could cause product damage.
If the dishwasher does not operate:
Check these points:
l Is the door closed tightly and latched securely?
l Has the cycle been set correctly to start the dishwasher?
l Is the water turned on?
l Has a house fuse blown or a circuit breaker tripped?
l Has electrical power been interrupted?
114” z=----23-g” 6”-
n
r
18- 1316”*
1” 5116” routed top and side ed es for panel more than l/4” thic ii .
After custom panels are installed, check the door tension. The door should be counterbalanced so it doesn’t fall open or close when opened. If the door closes from an open position, adjust the door- spring brackets upward to a different hole. If door falls open too quickly, move spring bracket downward. If custom panels are heavy,
Note: If the motor has stopped because of overload, it will automatically reset itself within a few minutes.
If you need
assistance...
The KitchenAid Consumer Assistance Center will answer any questions about operating or maintaining your appliances not covered in the Installation Instructions. The KitchenAid Consumer Assistance Center is open.24 hours a day, 7 days a week. Just dial (800)
When you call, you will need the appliance model number and serial number. Both numbers can be found on the serial/rating plate located on the front frame behind the door.
If you need
service...
*For Models: KUDA220T and
**Raised door panel must have a 1” minimum routed bottom edge to prevent door panel from contacting the access panel when door is opened.
Custom wood or other materials should be l/4” thick. Thinner materials will need to have a spacer panel installed behind custom panel. If custom panel is more than l/4” thick, the outer edge will need to be routed as shown. Custom wood panels need a waterproof protective finish applied to all sides and edges of panel.
Part No. 9741159 |
|
01992 KitchenAid | Prepared by KitchenAid@, St. Joseph, Michigan 49085 |
In the event that your KitchenAid appliance should need service, call the dealer from whom you purchased the appliance or a KitchenAid authorized service company. A KitchenAid authorized service company is listed in the Yellow Pages of your telephone directory under “Appliances - Household - Major - Service or Repair”. You can also obtain the service company’s name and telephone number by dialing, free, within the continental United States, telephone number, (800)
Printed in U.S.A.