back of dishwasher
n-l m
alternate position
rear Gross channel original position
Check to see if rear cross channel contacts drain,
electrical or water lines. If the channel contacts any line, pull dishwasher out of opening. Do Not remove the channel. Remove both cross channel screws on the
/
dishwasher valve 9
d h
| at drain hose is not |
|
kinked, | crimped or contactins |
|
electrical | - |
Place towel below dishwasher valve area.
Remove red plug from dishwasher valve. (A small amount of water may still be in the valve area from quality assurance testing.) Place hose clamp over dishwasher valve. Connect drain hose to valve and secure with hose clamp. Check for good fit and that there are no bends or kinks in drain hose that could restrict water flow.
top mounting
,brackets,
Do Not drop screws into tub.
deep through bracket holes into the underside of countertop using a l/8” drill bit. Do Not exceed 3/4” depth.
Attach brackets to underside of countertop. Make sure the screw heads do not interfere with door.
You MUST secure dishwasher to keep it from tilting when door is opened or closed. Do Not drop screws in dishwasher tub. If screws should fall into pump, pump and motor failure may occur. Remove paper from bottom of dishwasher.
If brackets cannot be attached to countertop, attach dishwasher to floor using l/4” lag bolts through hole in each side of dishwasher frame.
, equally spaced,
Align dishwasher door with cabinet front, not doors.
compression elbow (3/8” N PT one end). Connect street elbow to water valve. Connect supply line to compression elbow. If galvanized pipe is used, use a second 3/8” street elbow in place of the compression elbow.
Page 6
Open dishwasher and remove foam shipping pieces from upper corners of boor.
Remove bottom rack. Place a newspaper or large sheet of paper over bottom of dishwasher to protect the pump area when securing dishwasher to countertop.
Disconnect brackets located at the top
corners of flange. Reattach brackets with bracket end facing away from dishwasher. Drill starter holes 3/4”
Open door approximately 3” and check for equal
spacing between inner door and tub sides. If necessary, loosen screws that fasten dishwasher to countertop and shift tub. Retighten screws.
Place level against interior flange as
shown. Level dishwasher front to back and side to side by adjusting leveling legs.