KitchenAid DHT-486XP manual Door swing dimensions, Anti-tip requirements, Tipping radius

Door swing dimensions								36"	42"	48"
								91 cm	106 cm	122 cm
							A	38-1/2"	41"	43-1/2"
								(98 cm)	(104 cm)	(110 cm)
							B	36-1/16"	38"	40"
	F							(92 cm)	(97 cm)	(102 cm)
					E
							C	43-1/2"	47"	50-1/2"
								(110 cm)	(119 cm)	(128 cm)
B
							D	40"	42-9/16"	45-1/4"
			Top front					(102 cm)	(108 cm)	(115 cm)
		A
						D
			of refrigerator	C			E	19-3/4"	23-1/4"	26-3/4"
								(50 cm)	(59 cm)	(68 cm)
							F	14-1/2"	17-1/4"	19-3/4"
								(37 cm)	(44 cm)	(50 cm)

			Location must permit doors to open
90°		Refrigerator	to 90° min. Allow 4-1/2 inch
		door	(11.4 cm) min. space between
130°			refrigerator side and corner wall.
Freezer	130°	90°	Anti-tip requirements
door
			1/4" (6 mm) max.	Two, 2" x 4" x
				32" (5 cm x 10
Tipping radius				cm x 81 cm)
				anti-tip wood
Note: Dolly wheel height must be added to tipping				boards
				Attach to wall
radius when a dolly is used.			2" (5 cm)
				studs with six,
			min.
				#8 x 3" (76 mm)
Forward/backward				(or longer)
				wood screws.
tipping radius
				Boards must be
				long enough to
				fully cover
				width of
				compressor
				cover.
	A
Side
tipping radius
				rear
				wall

If boards are placed before installation of refrigerator, locate boards so the bottom surface of the boards are 84 inches (213 cm) from the floor. During installation, raise the refrigerator up so there is 1/4 inch (6 mm) maximum between top of refrigerator and bottom of anti-tip boards.

			If solid soffit is 1 inch (2.5 cm) above
	B
			refrigerator, anti-tip wood boards are not required.
			If solid soffit is not available or soffit is more than
Size	A	B	1 inch (2.5 cm) above cover, center wood boards
			on rear wall 1/4 inch (6 mm) maximum above
36" (91 cm)	87-1/4" (222 cm)	90-1/2" (230 cm)
			refrigerator. Attach wood boards to wall studs with
42" (106 cm)	87-1/4" (222 cm)	93" (236 cm)	wood screws — making sure that screws are
48" (122 cm)	87-1/4" (222 cm)	96" (244 cm)	engaged in wall studs 1-1/2 inch (3.8 cm) minimum
			and that boards extend 2 inches (5 cm) minimum

over the top rear of refrigerator compressor cover.

Page 4