top grille assembly
decorative panel
assembly
14.Wraparound stainless steel door models: go to step 17.
Panel models: Slide decorative panel assembly up to remove from top grille assembly.
remove 2
screws
top grille decorative panel
18. If side panels are not used, go to Step 19.
If
(63.5 cm) or more, side panels can be installed inside the side trim or attached to the outside of the side trim.
Top view
rear wall
support board
A
side panel
B
side trim door
| Panel | Wraparound |
| models (shown) | stainless steel |
|
| door models |
A | 24" | 23" |
| (61 cm) | (58.4 cm) |
B | ||
| (62.5 cm max.) | (59.4 cm) |
|
|
|
screws
bottom grille
19. Open refrigerator doors and remove protective film from door frame. Recheck water connections at bottom of refrigerator for leaks.
Attach bottom grille to cabinet with two screws. Install shelves and bins in refrigerator and freezer compartments.
20. Set refrigerator and freezer compartment controls to the midpoint between “COLD” and “COLDEST.” Check that the compressor is operating properly and that all five lights are working.
15. Panel models: Remove screws and side trim from one side of the decorative panel. Insert your panel. Reattach side trim and screws.
16. Panel models: Slide decorative panel down to reattach to top grille.
cabinet
cabinet grille panel side trim side trim
•Inside side trim piece: Slide front edge of routed side panel into trim piece. Nail rear edge of panel to support board.
NOTE: KitchenAid is not responsible for the removal or addition of molding or decorative panels that would prevent the refrigerator from being serviced.
To get the most efficient use from your new
grille panel | louver | |
assembly | ||
screws | ||
|
17. Wraparound stainless steel models: If additional ceiling clearance is required for tipping the refrigerator, the top grille and cabinet side trim can be removed. Slide the louver assembly up to remove from the top grille. Remove two screws from the grille panel and slide the grille panel down to remove from the refrigerator. Remove the screws (six each side) attaching the cabinet side trim to the refrigerator. Reassemble after dolly has been removed from refrigerator.
Part No. 2006137 Rev. A
© 1999 KitchenAid.
®Registered Trademark/Trademark of KitchenAid U.S.A., KitchenAid Canada licensee in Canada
®
HOME APPLIANCES
Prepared by KitchenAid, Benton Harbor, Michigan 49022 | Printed in U.S.A. |