Install Anti-Tip Bracket
1.Remove the
2.Determine which mounting method to use: floor or wall.
If you have a stone or masonry floor you can use the wall mounting method.
3.Determine and mark the edge of the range in the cutout space. The mounting bracket can be installed on either the left side or right side of the cutout. Position mounting bracket in cutout so that right (or left) edge of the bracket is
⁹⁄₁₆" (14.5 mm) from the marked edge of the range, as shown.
A
B
C
A.
B.Mark edge of range.
C.⁹⁄₁₆" (14.5 mm)
4.Drill two ¹⁄₈" (3.0 mm) holes that correspond to the bracket holes of the determined mounting method. See below.
Floor Mounting
AB
A. #12 x 1⁵⁄₈" screws
B.
Wall Mounting
AB
A. #12 x 1⁵⁄₈" screws
B.
5.Using the Phillips screwdriver, mount
Make Gas Connection
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and authorized service personnel.
Failure to do so can result in death, explosion, or fire.
Typical flexible connection
1.Apply
2.Attach one adapter to the gas pressure regulator and the other adapter to the gas shutoff valve. Tighten both adapters.
8