arb
TO ASSEMBLE:
|
| H |
| B | E |
A | D | |
|
| |
C |
|
|
| F | G |
|
|
Slide smaller end of spring and shaft assembly (A) into opening in larger worm (B) until secured firmly in place. Insert the larger worm into the grinder body (C). Attach strainer cone (D) over the exposed end of the worm matching the tabs of the cone with the notches in the grinder body. Place ring (E) onto grinder body, turning by hand until finger tight but not overtightened.
Note: Do not use wrench (F) to tighten ring, only to remove. Slide the strainer tray
(G) over the cone and latch on top of ring. Place splash shield (H) on strainer tray.
TO ATTACH:
2 3 1
Before attaching accessory, turn off and unplug unit.
Loosen attachment knob (1) by turning it counterclockwise. Remove attach- ment hub cover. Insert attachment shaft housing (2) into attachment hub
(3)making certain that attachment power shaft fits into square hub socket. Rotate attachment back and forth if necessary. When attachment is in proper position, the pin on the attach- ment will fit into the notch on the hub. Tighten attachment knob until attach- ment is completely secured to mixer.
TO USE:
! | WARNING | |||
| ý |
| Rotating Blade Hazard |
|
|
|
| ||
|
|
|
| |
|
|
| Always use food |
|
|
|
| pusher. |
|
|
|
| Keep fingers out of |
|
|
|
| openings. |
|
|
|
| Keep away from |
|
|
|
| children. |
|
|
|
| Failure to do so can |
|
|
|
| result in cuts or other |
|
|
|
| injury. |
|
|
|
|
|
|
After attaching unit to mixer, place mixer bowl under strainer tray to catch strained food and a smaller bowl under open end to catch food waste. Cut food into pieces that will fit in the hop- per. Turn mixer to Speed 4 and feed food into hopper using stromper.
3
