CabinetCutout Dimensions
35½"
(90.2 cm)
10 ¾"
(27.3 cm)
1¹⁄₂"
(3.8 cm)
20 ⁵⁄₈" (52.5 cm)
A | 2 ⁵⁄₈" |
| (6.8 cm) |
B 
1¹⁄₂" (2.9 cm) min around
opening for mounting optional doors or drawers
| A |
Double Access Doors | Cutout Width |
|
|
27" (68.6 cm) | 25¹⁄₈" (64.1 cm) |
|
|
30" (76.2 cm) | 28¹⁄₈" (71.1 cm) |
|
|
36" (91.4 cm) | 34¹⁄₈" (87.0 cm) |
|
|
48" (121.9 cm) | 46¹⁄₈" (117.4 cm) |
| B |
Single Access Door | Cutout Width |
|
|
18" (45.7 cm) | 16³⁄₁₆" (41.1 cm) |
|
|
INSTALLATION INSTRUCTIONS
1.Remove access doors from mounting frame by lifting each door up and off the mounting frame hinge.
2.Install mounting frame flush to the face of the cabinet cutout. Make sure the mounting frame is level.
3.Install screws (not supplied) into holes located on the mounting frame.
4.Replace access doors by placing each door back on the mounting frame hinges.
ACCESS DOORS CARE
General Cleaning
IMPORTANT: Always follow label instructions on cleaning products.
Soap, water and a soft cloth or sponge are suggested first unless otherwise noted.
To avoid damage to stainless steel surfaces, do not use soap- filled scouring pads, abrasive cleaners, cleaners containing chlorine, Cooktop Polishing Creme,
STAINLESS STEEL
Cleaning Method:
Rub in direction of grain to avoid damage.
■Food spills should be cleaned as soon as possible. Spills may cause permanent discoloration. Use stainless steel cleaner and polish to clean spills.
KitchenAid® Stainless Steel Cleaner and Polish Part Number 4396920 (not included) or KitchenAid® Stainless Steel Wipes Part Number 8212510 (not included):
See “Assistance or Service” section to order.
■Liquid detergent or
Rinse with clean water and dry with soft,
■Vinegar for hard water spots
■Use a glass cleaner to remove fingerprints.
EXTERIOR and INTERIOR
The quality of this material resists most stains and pitting, providing that the surface is kept clean, covered and polished.
Cleaning Method:
■Apply stainless steel polish to all areas before first use. Apply after each cleaning to avoid damage.
■Cleaning should always be followed by rinsing with clean, warm water.
■Use a metal polish or stainless steel brightener to remove fingerprints, water spots, oxidation, and food stains. Always follow the manufacturer’s directions.
■Wipe the surface completely dry with a soft cloth.
4
