KitchenAid KBRA20ELBT0 Performance Data Sheets, Application Guidelines/Water Supply Parameters

PERFORMANCE DATA SHEETS

Interior Water Filtration System

Model OWF50-NI300 capacity 300 Gallons (1136 Liters)

Tested and Certified by NSF International against ANSI/NSF Standards

42 & 53 for the reduction of:

Standard No. 42: Aesthetic Effects

Taste & Odor Reduction

Chlorine Reduction

Mechanical Filtration Unit

Particlate Reduction Class 1

Standard No. 53: Health Effects

Chemical Reduction Unit

Lead, Atrazine, Lindane & 2,4-D Reduction

Mechanical Filtration Unit

Cyst, Turbidity, & Asbestos Reduction

This system has been tested according to ANSI/NSF 42/53 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in ANSI/NSF 42/53. Systems certified for cyst reduction may be used on disinfected water that may contain filterable cysts.

Substance	Influent Challenge	Effluent Average	Average %	Max. Effluent	Min. Required	Inlet pH
	Concentration		Reduction		Reduction
Lead:	0.15 mg/L ± 10%	0.001 mg/L	99.33%	0.001 mg/L	0.010 mg/L	6.5
Lead:	0.15 mg/L ± 10%	0.002 mg/L	98.66%	0.003 mg/L	0.010 mg/L	8.5
Cyst	Minimum 50,000 L	1 count/mL	99.99%	3 count/mL	> 99.95%	NA
Turbidity	11 ± 1 NTU	0.12 NTU	98.98%	0.18 NTU	0.5 NTU	NA
Lindane	0.002 mg/L ± 10%	0.00005 mg/L	97.62%	0.00005 mg/L	0.00002 mg/L	NA
Atrazine	0.009 mg/L ± 10%	0.0002 mg/L	97.93%	0.0006 mg/L	0.003 mg/L	NA
Chlorine	2.0 mg/L ± 10%	0.09 mg/L	95.26%	0.17 mg/L	Š 75%	NA
Particulate*	at least 10,000 particles/mL	900 count/mL	99.68%	2400 count/mL	≥ 85%	NA
2,4-D	0.210 mg/L ± 10%	45.45 ug/L	84.42%	100 ug/L	0.0017 mg/L	NA
Asbestos	107 to 108 fibers/L; fibers greater	0.16 MFL/mL	99.96%	0.16 MFL/mL	99%	NA
	than 10 micrometers in length

* Particle size range classification of test. Particles used were 0.5 - 1 microns.

Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.75 gpm (2.83 Lpm). Pressure = 120 psi (827 kPa). Temp. = 63°F (17.2°C).

■It is essential that operational, maintenance, and filter replacement requirements be carried out for the product to perform as advertised.

■Using Replacement Cartridge OWF51 - Model OWF50- NI300: The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system as specified in ANSI/NSF 42 and 53. Change cartridge at least every 6-9 months. Use replacement cartridge OWF51, part# 4396395. 2003 suggested retail price of $29.95 U.S.A./$39.95 Canada. Prices subject to change without notice.

■The product is for cold water use only.

■Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

■Refer to the “Assistance or Service” section for parts and service availability or for the Manufacturer’s name, address and telephone number.

Pentapure Incorporated 1000 Apollo Road

Eagan, Minnesota 55121-2240 651-554-3141

®NSF is a registered trademark of NSF International.

■Refer to the “Warranty” section for the Manufacturer’s limited warranty.

■Note that while the testing was performed under standard laboratory conditions, actual performance may vary. Systems must be installed and operated in accordance with manufacturer’s recommended procedures and guidelines.

Application Guidelines/Water Supply Parameters

Water Pressure	35 - 120 psig (241 - 827 kPa)
Water Temperature	33° - 100°F (0.6° -	37.8° C)
Rated Service Flow	0.75 gpm (2.83	Lpm)

24