20
Low Flame Adjustment
If flame goes out on the “LO” setting, the low flame setting must
be adjusted.
1. Turn off the valve and wait until burners are cool.
2. Light side burner using information in the “Outdoor Side
Burner Use” section.
3. Turn burner to its lowest setting and remove knob.
4. Hold valve stem with pliers and insert a small flat-blade
screwdriver into the shaft.
5. Watch the flame and slowly turn the screwdriver
counterclockwise.
6. Adjust flame to minimum stable flame.
7. Replace the control knob and turn off the burner.
8. Repeat steps 3 through 7 for each burner if needed.
USING YOUR OUTDOOR SIDE BURNERInspect the LP Gas Fuel Tank Supply Hose
Inspect the gas pressure regulator/hose assembly before each
use.
1. Open the cabinet door and slide 20 lb LP gas fuel tank out.
2. Inspect the entire gas pressure regulator/hose assembly for
cuts, abrasions, or excessive wear.
3. If necessary, replace the gas pressure regulator/hose
assembly before using the side burner.
Contact the dealer and use only replacement hoses specified for
use with the side burner.
Prepare the Gas Supply
1. Remove outdoor side burner cover.
2. Make sure the control knobs are all turned to the OFF
position.
Turn the Gas Supply On
1. For outdoor side burners using a 20 lb LP gas fuel tank:
Slowly open the tank valve.
NOTE: If flow limiting device activates, your side burner may
not light. If your side burner does light, the flames will be low
and will not heat properly. Turn 20lb LP gas fuel tank valve
and all control knobs off and wait 30 seconds. After shutting
off the 20lb LP gas fuel tank, very slowly open tank valve and
wait 5 seconds before lighting.
2. For outdoor side burners using gas supply source other than
20 lb LP gas fuel tank:
Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
Lighting Your Side Burner
1. Remove the side burner cover. Do not light burners with the
cover on.
2. Do not lean over the side burner.
3. Push in and turn the control knob to LITE/HI and hold in.
4. You will see the igniter glow. When burner is lit, release the
knob. Turn knob to desired setting.
5. Repeat for the other burner as needed.
IMPORTANT: If burner does not light immediately, turn the
burner knob to OFF and wait 5 minutes before relighting.
A.Valve stem
B.Small flat-blade screwdriver
C.Pliers
A
BC
A.Gas pressure regulator/hose assembly
A
WARNING
Burn HazardDo not let the burner flame extend beyond the edge of the pan.Doing so can result in burns.WARNING