hose/regulator
assembly

8. Carefully lift grill grates off of grill area and set aside.

9. Remove sear plates and set aside.

sear plate

10. Remove tiedowns from burners and warming shelf.

warming

shelf

remove tiedowns

remove

tiedowns

burner

11. Reinstall sear plates. Make sure sear plates are resting on pins.

pins

12. Carefully slide grill completely into outdoor enclosure.

13. Now go to the "Checking and Adjusting Burners Section."

If converted to

L.P. Gas

WARNING

Explosion Hazard

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure gas pressure does not exceed 11” (28 cm) water column.

Examples of a qualified person include:

licensed heating personnel, authorized gas company personnel, and,

authorized service personnel.

Failure to do so can result in death, explosion, or fire.

1. Make gas connections.

L.P./Propane: A 20 lb. L.P. tank must be purchased separately. Install the tank into the compartment below the grill and screw the hose/regulator assembly to tank as shown.

The pressure regulator and hose assembly supplied with the grill must be used. Replacement pressure regulator and hose

assembly specific to your model, is available from your outdoor grill dealer.

If converting to natural gas, see conversion kit requirements and “Gas supply requirements” section. Follow instructions included with kit.

2.Turn on the gas supply. Wait a few minutes for gas to move through the gas line.

3.Test all connections by brushing on an approved non-corrosive leak-detection solution. Bubbles will show a leak. Correct any leak found.

4. Go to “Checking and adjusting the burners” section.

10

Page 10
Image 10
KitchenAid KFGR274PSS, KFGR382PSS, KFGR364PSS If converted to Gas, Remove tiedowns from burners and warming shelf